Search All UNICOM Global Sites

shopping_cart_icon.gif Where to Buy     region_icon.gif Change Region

Latest News
3.31.2016 :: UNICOM® Global Acquires IBM® WebSphere® Multichannel Bank Transformation Toolkit from IBM Corp.
2.18.2016 :: UNICOM® Global Announces the CEO/CIO Symposium and TeamBLUE™ User Group Meetings 2016
1.31.2016 :: UNICOM Global CEO Corry Hong Interviewed in Enterprise Executive Magazine
12.31.2015 :: UNICOM® Global Acquires IBM® Rational® System Architect from IBM Corp.
12.15.2015 :: UNICOM® Global Buys Washington Technology Park I & II

USR8500 USRobotics USB ADSL Modem
Manuals and other Documents

OS Compatibility


2012 R2







Vista 64

XP 64





98 SE

98 FE





Drivers and Firmware
Windows 98, Me, and 2000 drivers
Note: In order to prevent your browser from trying to open these files, right-click on the file and select Save Target As... to download.

This zip file contains the drivers for the USRobotics USB ADSL Modem. Follow these steps to install the drivers:
  1. Download the file to a temporary location on your computers hard disk drive such as C:\temp.
  2. If you have not already done so, connect the modem to your PC using the provided USB cable and connect the RJ-11 phone cord to the DSL jack on the ADSL Modem.
  3. Windows will automatically detect the USB ADSL modem and launch the Add/Remove Hardware Wizard. Select the location to which you extracted the contents of the file and click Next. Follow the prompts to complete the installation.
  4. Configure the DSL software settings using the required settings provided by your DSL Service Provider. Refer to the USB ADSL Modem Manual for further assistance, if needed.
usb-adsl-drivers.zip3.19 MB 06-26-01

Beta Drivers for Macintosh

Note: This file only works on Macintosh operating systems 9.2 and earlier.

Follow the directions below to download the drivers.

  1. Double-click the driver and unstuffit. The main folder will appear.
  2. Click the main folder and click DSL Modem Install_EN Disk.
  3. Click Installer and follow the instructions.
  4. Connect the modem to your computer using the provided USB cable and connect the RJ-11 phone cord to the DSL jack on the ADSL Modem.
Note: Shortly after the modem is plugged in, the Power and Data LEDs should start blinking. To verify the ADSL connection, click Control Panel and then ADSL Setup. DSL connection information will appear.

USRobotics is providing this beta driver set as is and is currently offering limited support, staying consistent with the drivers on this page

USR_3Mbps_1.1.0008Q.sea.hqx1.37 MB03-06-02