The Wireless MAXg Detection Utility is not locating the Bridge to which I want to connect.

Possible Solution:

Verify that all the physical connections of the Bridge are securely connected.

Possible Solution:

Click Detect to rescan the network.

Possible Solution:

If the Bridge to which you want to connect is not located after you click Detect, perform the following steps:

  1. The networking device (e.g. router or access point) that the Bridge is connected to probably has some form of Web User Interface where you can view a client list. Perform the neccesary steps to view this client list in your networking device. Refer to your networking device's documentation to determine how to view this information.
  2. Locate the Bridge in the client list by verifying the LAN MAC address that is on the bottom label of the Bridge and what appears in the client list. Write down the IP address of the Bridge for future reference.
  3. Open a Web browser, type in the IP address of the Bridge, and then press Enter. This will open the Web User Interface of the Bridge. Verify that all the connection information is correct for the network to which the Bridge is connected.

Return to Troubleshooting page