The Setup Wizard was unable to detect my Internet connection.

Possible Solution:

You will need to manually configure your Internet connection. There are two methods of instructions you can follow to set up your Internet connection: If you are still in the Setup Wizard or If you have already closed the Setup Wizard.

If you are still in the Setup Wizard:

  1. Select your Internet connection type: either Cable, DSL Router, satellite, ISN, LAN, or other or DSL modem (also known as PPPoE).



  2. Depending on your selection, you will need to enter some information that was provided by your ISP.
  3. After entering all of your necessary information, click Next.
  4. Continue to follow the on-screen instructions to complete the Setup Wizard. For more information about these settings, refer to the Configuration section of this User Guide.

If you have already closed the Setup Wizard:

  1. Start a Web browser. In the location or address line of your Web browser, type http://192.168.2.1 to log on and access the Web User Interface.
  2. Click the Internet tab. Select your Internet connection type: either Cable, DSL Router, satellite, ISN, LAN, or other or DSL modem (also known as PPPoE).



  3. Depending on your selection, you will need to enter some information that was provided by your ISP.
  4. When you are finished, click Save. You should now be able to access the Internet. For more information about these settings, refer to the Configuration section of this User Guide.

Return to Troubleshooting page