Assistenza


Questa pagina è predisposta per la stampa. Per stampare questo documento, clicca sul tasto stampa della barra del tuo browser. Al termine, clicca sul tasto chiudi, situato in alto a destra o in fondo alla pagina, per chiudere la finestra e tornare alla pagina precedente.


My Ethernet Switch is properly connected to my Ethernet-ready device, but I still can’t establish a connection.

Possible Solution:
Verify you are using a known and reliable RJ-45 Category 5 Ethernet cable. An old or unreliable RJ-45 Category Ethernet cable could disrupt your connection. It may be necessary to replace your RJ-45 Category 5 Ethernet cable.

Possible Solution:
Check the LED status lights on your 10/100 Ethernet Switch. A flashing yellow light indicates you are receiving and transmitting data at 10 Mbps. A flashing green light indicates you are receiving and transmitting data at 100 Mbps. If you don’t see any LEDs lighted or blinking, it may be necessary to replace your RJ-45 Category 5 Ethernet cable.

Possible Solution:
The length of your Ethernet cable between your 10/100 Ethernet Switch and your workstation or computer should not exceed 328 feet. Some power sources with strong electromagnetic fields may be causing interference.

Possible Solution:
It may be necessary to reconfigure the network settings of your operating system. Refer to your operating system’s documentation regarding network configuration specifics.


Queste FAQ (Domande Frequenti) ti sono state d’aiuto? (1 = nessun aiuto, 5 = grande aiuto)
1   2   3   4   5  
 
Ti hanno permesso di risolvere il problema?
Si   No   Non so (non ho ancora provato)  
 
Commento facoltativo (255 caratteri al massimo)

Chiudi finestra