Soporte


This page has been designed for printability. To print this document, click the Print button on your browser's toolbar. When you are finished, click the Close Window button located at the upper-right or bottom of the page to close this window and return to the previous page.


I want to change the setting from Static IP to Dynamic IP via the utility but I'm experiencing difficulties doing so.

If you want to change the setting from Static IP to Dynamic IP via the utility, follow the steps below:

  1. Open the Configuration Utility and edit a profile. Follow the on-screen instructions until you reach the IP Setting field.
  2. From the IP Setting field, select Enable and click Next, as demonstrated in the graphic below:
  3. In the DHCP Status field, select Enable and click Complete, as demonstrated in the graphic below:
  4. From the Profile tab, click Connect to the network that you just edited and make sure the Static IP address disappears by clicking More in the Link Status tab.
  5. You are now able to switch to a different network.

 

Was this FAQ helpful? (1 = not helpful, 5 = very helpful)
1   2   3   4   5  
 
Did it resolve your problem?
Yes Si   No   Not sure (haven't tried it yet)  
 
Additional Comments (255 characters maximum)

Close Window