This page has been designed for printability. To print this document, click the Print button on your browser's toolbar. When you are finished, click the Close Window button located at the upper-right or bottom of the page to close this window and return to the previous page.


Configuring Your Broadband Router for use with Analog Modems


  1. Connect your serial cable to your analog modem and to the COM port on the broadband router. Make sure the modem is powered on.
  2. Go to the Configuration Utility and click Primary Setup. Click Change and select the WAN type as Dialup Network.
  3. In the Baud Rate field, select the setting 115200 from the drop-down box for maximum throughput capabilities.
  4. In the Extra Settings field, insert AT&F1.
  5. Click Save and reboot the broadband router. Click Dial-up to initiate a dial-up session with your ISP. The peripheral status will display whether or not the call was successful. If the settings are correct, the analog modem will connect to the Internet. If you cannot connect to the Internet, verify you have entered all the correct values in the Primary Setup page before connecting to the Internet again.
  6. Note: For specific terms and definitions, access the Analog Glossary for more information.

     

Was this FAQ helpful? (1 = not helpful, 5 = very helpful)
1   2   3   4   5  
 
Did it resolve your problem?
Yes Yes   No   Not sure (haven't tried it yet)  
 
Additional Comments (255 characters maximum)

Close Window