Soporte


This page has been designed for printability. To print this document, click the Print button on your browser's toolbar. When you are finished, click the Close Window button located at the upper-right or bottom of the page to close this window and return to the previous page.


Can I use another manufacturer's detachable antenna with any of the following USRobotics products?

  • (USRxx2450) 11 Mbps Wireless Access Point
  • (USRxx2216) 22 Mbps Wireless PCI w/Detachable Antenna
  • (USRxx8022) 22 Mbps Wireless Cable/DSL Router
  • (USRxx5416) 100 Mbps Wireless Turbo PCI Adapter
  • (USRxx5430) 54 Mbps Wireless Gaming Adapter and Ethernet Bridge
  • (USRxx5450) 100 Mbps Wireless Turbo Multi-Function Access Point
  • (USRxx8054) 100 Mbps Wireless Wireless Turbo Router
  • (USRxx9106) 54 Mbps SureConnect Wireless Gateway


Europe Warning! Due to CE regulations, using any antenna other than the supplied antenna provided with your U.S. Robotics product will make this product CE non-compliant and will void your USRobotics warranty. Should you choose to replace the antenna that shipped with your product, specific USRobotics detachable antenna specifications are listed below.

North America Warning! Due to Federal Communications Commission (F.C.C.) regulations, using any antenna other than the supplied antenna provided with your USRobotics product will make this product FCC non-compliant and will void your USRobotics warranty. Currently, USRobotics is not offering the sale of any antennas as separate purchase items. Should you choose to replace the antenna that shipped with your product, specific USRobotics detachable antenna specifications are listed below.


USRobotics detachable antenna specifications:

    USRxx5416 100 Mbps Wireless Turbo PCI Adapter
    Removable 54 Mbps swivel dipole antenna with reverse polarity SMA connector (2 dB maximum gain).

    USRxx5430 54 Mbps Wireless Gaming Adapter and Ethernet Bridge
    Removable dipole antenna with Reverse Polarity SMA connector (2 dB maximum gain).

    USRxx5450 100 Mbps Wireless Turbo Multi-Function Access Point
    Dual swivel dipole removeable antennas with reverse polarity SMA connector (5 dB maximum gain).

    USRxx8054 100 Mbps Wireless Turbo Router
    Dual swivel dipole removeable antennas with reverse polarity SMA connector (2 dB maximum gain).

    USRxx2450 11 Mbps Wireless Access Point
    Removable dipole with Reverse Polarity TNC connector (2 dB maximum gain). Access Point has male connector and antenna has female connector.

    USRxx2216 22 Mbps Wireless Access PCI Adapter
    Removable dipole with Reverse Polarity SMA connector (2 dB maximum gain). PCI Card has male connector and antenna has female connector.

    USRxx8022 22 Mbps Wireless Cable/DSL Router
    Dual removable dipole with Reverse Polarity SMA connectors (2 dB maximum gain each). Wireless Router has 2 male connectors and both antennas are female connectors.

    USRxx9106 54 Mbps SureConnect Wireless Gateway
    Dual swivel dipole removeable antennas with reverse polarity SMA connector (2 dB maximum gain).


FCC Regulations

15.203 Antenna requirement
An intentional radiator shall be designed to ensure that no antenna other than that furnished by the responsible party shall be used with the device. The use of a permanently attached antenna or of an antenna that uses a unique coupling to the intentional radiator shall be considered sufficient to comply with the provisions of this section. The manufacturer may design the unit so that a broken antenna can be replaced by the user, but the use of a standard antenna jack or electrical connector is prohibited. This requirement does not apply to carrier current devices or to devices operated under the provisions of 15.211, 15.213, 15.217, 15.219, or 15.221*. Further, this requirement does not apply to intentional radiators that must be professionally installed, such as perimeter protection systems and some field disturbance sensors, or to other intentional radiators which, in accordance with 15.31(d) , must be measured at the installation site. However, the installer shall be responsible for ensuring that the proper antenna is employed so that the limits in this part are not exceeded.

*FCC Provisions 15.211, 15.213, 15.217, 15.219, and 15.221 do not pertain to the use of wireless antennas for our products.

CE Regulations

In Europe, installation and usage of antennas are subject to European regulations as set in the 1999/05/CE (R&TTE) directive. Any combination of radio equipment and antenna must be assessed together to insure conformity to the CE regulation. For addional information refer to http://europa.eu.int for the conformity requirements or contact your local spectrum authority http://europa.eu.int, for further details on national restrictions.

Was this FAQ helpful? (1 = not helpful, 5 = very helpful)
1   2   3   4   5  
 
Did it resolve your problem?
Yes Si   No   Not sure (haven't tried it yet)  
 
Additional Comments (255 characters maximum)

Close Window