Soporte



Serial Cable Pinouts

Pinout List For RS-232 Serial Cables

This page has been designed for printability. To print this document, click the Print button on your browser's toolbar. When you are finished, click the Close Window button located at the upper-right or bottom of the page to close this window and return to the previous page.

DB-25

DB-9

Circuit

Function

-----

AA

Chassis Ground

2

3

BA

Transmitted Data

3

2

BB

Received Data

4

7

CA

Request To Send

5

8

CB

Clear To Send

6

6

CC

Data Set Ready

7

5

AB

Signal Ground

8

1

CF

Carrier Detect

12

-----

SCF

Speed Indicate

20

4

CD

Data Terminal Ready

22

9

CE

Ring Indicate

The Minimum required pins needed for the modem to operate are: Data, Signal Ground and Data Terminal Ready (unless DIP 1 is down).

Also, the sources of the signal are:
1 and 7 are supplied by both the Terminal and the Modem
2,4,20 are supplied by the Terminal
3,5,6,8,12,22 are supplied by the Modem


For a Macintosh 8-pin DIN:

DB-25

Macintosh

2

3

Transmitted Data

3

5

Received Data

4

1

Request To Send

5

2

Clear To Send

7

4

Ground

20

1

Data Terminal Ready

Note: On a Mac, the DTR is tied to the RTS line. This makes it necessary to override DTR(dip 1 down).

Was this FAQ helpful? (1 = not helpful, 5 = very helpful)
1   2   3   4   5  
 
Did it resolve your problem?
Yes Si   No   Not sure (haven't tried it yet)  
 
Additional Comments (255 characters maximum)

Close Window